Hyundai Haze Blue Pearl (XU6) Touch Up Paint

The Look

Your Genesis Coupe belongs to a very specific era of Korean performance, and this color was the moody, sophisticated choice for drivers who wanted to stand out without screaming for attention. Since your car has likely been on the road for about a decade, you will notice that the finish has a deep, oceanic quality that shifts from a dusty slate to a vibrant teal under direct sunlight. It is not a loud, bright blue; instead, it carries a heavy dose of grey that gives the car a more expensive, grounded appearance than the typical street racer shades.

Technical Details

This is a pearl finish, which means it contains microscopic mica flakes rather than just standard metallic bits. These flakes create depth by reflecting light at different angles, but they can be temperamental during a repair. If you apply the paint too heavily in one spot, the flakes will sink and create a dark, muddy patch known as mottling. To keep the finish looking consistent with the rest of your panels, you need to focus on thin, even layers. Because this is a pearl, the final look depends entirely on how those flakes lay down, so rushing the job will lead to a finish that looks blotchy compared to the factory paint.

Best Practices

Before you spray or dab Hyundai Haze Blue Pearl (check for code XU6), you need to shake it for 60 seconds. You can verify your color code on the black or silver identification plate located inside the driver's side door jamb, usually right on the center pillar. Once you are ready to work, move your car into a cool garage or the shade to ensure the surface isn't hot to the touch. Test the color on the included card first to see how the pearl reflects light. When you apply the paint, keep the container moving at all times to prevent the mica from clustering. If you are using a pen or brush, use light strokes and allow for a ten-minute drying time between each layer to build the color gradually.